Published 18 November 2026 at 15:36
You measure a cylinder bore twice with the same instrument and get two different values. The difference is a few hundredths of a millimeter, and nobody knows whether it is the bore or the hand that has moved. With a two-point instrument, the measuring head must be held exactly perpendicular to the bore axis and contact must be made across the true diameter. This takes practice and is difficult to repeat between different operators.
What the instrument is
This is a digital internal three-point micrometer of the Holtest type for bores between Ø50 and Ø100 mm. Three measuring faces are positioned 120° apart around the axis and center themselves in the bore. This means you do not have to find the right position by hand. The measuring faces are made of carbide, the resolution is 0.001 mm, and the instrument is supplied as a set in an aluminum case with a 150 mm extension. With extensions, you can reach a maximum measuring depth of 1100 mm.
What problems it solves
The self-centering geometry eliminates the error caused by the instrument tilting. It also means you read a true diameter even when the bore is slightly oval. Because you can measure at several depths along the bore, you can also see whether the bore is tapered or has a barrel or hourglass shape. This is difficult to detect with a two-point instrument, and these are exactly the deviations that cause leakage, play or premature wear.
When and how it is used
You zero the instrument against a setting ring of nominal diameter, insert the measuring head into the bore and read the value once all three measuring faces are in contact. The display can switch between mm and inch and between ABS and INC. With preset, you can set the nominal size and read the deviation directly, which is quick in series production. The instrument switches itself off to save the battery (V357), and the IP54 rating protects against dust and splashes in a workshop environment.
Three use cases
In the machine shop industry, machined housings and bearing seats are measured right at the machine. The operator sees the trend in diameter and can correct for tool wear before the parts end up out of tolerance. In hydraulics and cylinder work, cylinder tubes and compressor cylinders are checked along their full length using an extension, so that taper and ovality are documented and not just assumed. In calibration and quality labs, the instrument is used where two-point measurement does not provide sufficient repeatability and where the measurement must be repeatable by different people with the same result.
Why it pays off
The expensive part of bore measurement is seldom the instrument. It is the scrap, rework and complaints caused by measurement uncertainty. When the result no longer depends on who is holding the instrument, the number of rechecks falls, and there are fewer discussions about which value is correct. A measuring tool that saves a few minutes per inspection and avoids the occasional wrongly approved part has often paid for itself within a short time in an operation that measures bores daily. Also keep in mind that the setting ring needs to be traceably calibrated, since it determines the zero point for all measurements.
If you measure bores in the 50–100 mm range and want to remove the operator’s influence on the result, the full specification is available on the product page.