Published 21 November 2026 at 11:20
Most people who have worked in production have been through it: a pump or fan that ”sounds a bit different”, an assessment by ear and a collective shrug. A few weeks later the line is at a standstill, and the spare part is in another time zone. The problem is seldom that nobody noticed something, but that nobody could show how much it had changed and how quickly.
What the instrument is
This is a handheld vibration meter with SD logger. Measurement is carried out with a separate probe on a 1.2-metre cable, which is attached with a magnet directly to the machine housing. The frequency range is 10 Hz to 1 kHz, the accuracy ±5%, and the instrument complies with ISO 2954. You can choose between RMS, peak value and Max Hold. The measured values are shown on a large backlit display and can be saved, either manually (99 values) or continuously to an SD card (up to 20,000 values) in a format that can be opened in Excel.
What problems it solves
A single reading only shows the situation at that moment. The logger shows the trend: how the level changes over hours, over a shift or between different operating modes. With the offset function you can zero against a reference value and measure relatively, for example against how the machine behaved when it was freshly serviced. Max Hold captures short peaks that you would otherwise miss when standing next to the machine with your eyes on the display. The magnetic mount means the measuring point is the same every time, which is a prerequisite for comparisons over time to mean anything.
When and why it is used
The instrument is suited to recurring rounds in preventive maintenance, to checks after a bearing replacement or realignment, and to documenting the condition of a machine at delivery or in warranty cases. It is also useful when you want to know whether a suspected disturbance is linked to a certain rotational speed or a particular process.
Three use cases
Engineering workshops: A spindle or coolant pump is measured at the same points every month. When the values start to rise, the bearing replacement is scheduled for a regular stop instead of happening as an emergency.
Food production: Fans and compressors in cold and freezer rooms run around the clock. The logger is placed on the machine for a couple of hours and shows whether the vibrations follow the load or grow independently of it.
Ventilation and property management: After an installation, you can measure the fan unit against a reference value and write down the result. This provides documentation should the unit later become a subject of discussion between contractor and client.
Why it pays off
The cost of an unplanned stop is almost always higher than the cost of the component that caused it. When bearing replacements can be planned in advance, emergency spare-part orders, overtime and consequential damage to shafts and housings are reduced. It also becomes easier to determine when a machine actually needs attention, so you avoid replacing parts as a precaution that still have a long service life left. The instrument is delivered complete with probe, magnetic mount, SD card, batteries and carrying case, so you can start measuring right away.
If you want to move from gut feeling to measured values on your rotating machinery, you can read more about the vibration meter here.